Horizontal Watch Stand

Every day when I get to work, I take my watch off and place it on my desk. Every watch stand I've tried has a tilt to it and my watch absolutely loves to turn and fall off the stand every chance it gets. I designed this simple watch stand so I could simply set my watch completely flat and not have to worry about it moving its position. The stand is approximately 126mm tall (5 inches) to ensure that the watch band stays off from touching my desk while the clasp is open. The platform that the watch sits on it approximately 44mm (1.7 inches) by 55mm (2.2 inches). This model can be scaled up or down easily to ensure that you get a good fit for your watch. This model is best printed at a 45-degree angle to reduce the amount of support but also adds strength to the print. Watch Stand Print Settings: ~37g total filament and ~2 Hours-0.2mm layer height-2 wall loops-20% infill-Enable Support(Tree Auto)