Thingiverse
Hose Separator
von marin1401
11
Downloads
32
Likes
0
Makes
Separate and hold two rubber hoses (outer diameter 16 mm) together. Distance in between hoses is about 7 mm. For different outer diameter (OD) values you can simply scale the model in your slicer by using the factor
F = OD/16 (mm),
in which OD is your hose outer diameter in millimeters.
Note that separator thickness may get too small or too big if you deviate too much from the reference 16 mm OD value.
Model units: Millimeters (mm).
Please consider tipping/donating through the link below if you have use of my design. Any amount is greatly appreciated.
https://www.paypal.com/paypalme/marin1401
F = OD/16 (mm),
in which OD is your hose outer diameter in millimeters.
Note that separator thickness may get too small or too big if you deviate too much from the reference 16 mm OD value.
Model units: Millimeters (mm).
Please consider tipping/donating through the link below if you have use of my design. Any amount is greatly appreciated.
https://www.paypal.com/paypalme/marin1401
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
