Thingiverse
Hot End LED Light
door Kr1tzel
11
Downloads
4
Likes
0
Makes
This is my first contribution. Please forgive me, if information is missing. :)
I created this LED holder for the print head inspired by the LED Ring Holder and because that does not fit with the two sided fan duct, which I'm using on my printer as well.
It does not provide light all around the hot end, but at least provides light to the front and right hand side of the print head.
I designed it thin, so I could reuse the original screws for the cold end fan that still fit. I have replaced the original "turbine" noisy fan with the Noctua (what a relief). And the original screws still fit.
For light I cut two 5cm strips from a waterproof (just had that at hand) light strip. The light strip is 8mm wide and fits exactly into the groove on the part.
I printed it upright with no supoort.
I created this LED holder for the print head inspired by the LED Ring Holder and because that does not fit with the two sided fan duct, which I'm using on my printer as well.
It does not provide light all around the hot end, but at least provides light to the front and right hand side of the print head.
I designed it thin, so I could reuse the original screws for the cold end fan that still fit. I have replaced the original "turbine" noisy fan with the Noctua (what a relief). And the original screws still fit.
For light I cut two 5cm strips from a waterproof (just had that at hand) light strip. The light strip is 8mm wide and fits exactly into the groove on the part.
I printed it upright with no supoort.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!