Thingiverse
Hot End
door jlnhab
17
Downloads
59
Likes
0
Makes
My last hot end.
Temperatures were taken with a thermocouple in direct contact with the inside of the nozzle.
The temperature measured at the end of the threaded M6 rod, stabilises at 46°C above the room temperature when the hot end is kept at 250°C.
I had to set the temperature at 273°C in order to reach 250°C.
But I used the distribution table for the thermistor.
Temperatures were taken with a thermocouple in direct contact with the inside of the nozzle.
The temperature measured at the end of the threaded M6 rod, stabilises at 46°C above the room temperature when the hot end is kept at 250°C.
I had to set the temperature at 273°C in order to reach 250°C.
But I used the distribution table for the thermistor.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
