Thingiverse
Hot End
von kenwshmt
2
Downloads
1
Likes
0
Makes
Hot End model.
A direct modification of anode505's J-head model.
73mm tall
16 mm wide.
The base lip is 2 mm thick.
Print slowly or your printer may break it off the bed.
It is almost solid, other than the 5mm hole through the middle.
A direct modification of anode505's J-head model.
73mm tall
16 mm wide.
The base lip is 2 mm thick.
Print slowly or your printer may break it off the bed.
It is almost solid, other than the 5mm hole through the middle.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
