Thingiverse
Hot Shoe Adapter
by cooasty
31
Downloads
23
Likes
0
Makes
Low profile Nikon hot shoe adapter to Sony/Minolta flash.
Printed at 40% speed. Handle printed better at 20%.
No electrical connection option provided with V1.
V2 adapter with electrical connection option. No TTL. Can be used with a flash fill. My camera works best in most cases with the light on continuously.
Cleaned holes with #52 drill bit. Used #14 bare copper wire for the pins. A slight friction fit is optimal. Slight cuts with a diagonal cutter will help this.
The pins should protrude slightly above the print before sliding the flash head on.
I rounded the pin ends before the final install. Mount the build, insert the pins and then the flash.
Check to see if every thing is pushed all the way in. May require some movement to seat the pins.
I believe it can be purchased on line as a C-S1 Hot Shoe Converter Adapter
for Canon/Nikon Camera to a Sony/Minolta Flash.
Printed at 40% speed. Handle printed better at 20%.
No electrical connection option provided with V1.
V2 adapter with electrical connection option. No TTL. Can be used with a flash fill. My camera works best in most cases with the light on continuously.
Cleaned holes with #52 drill bit. Used #14 bare copper wire for the pins. A slight friction fit is optimal. Slight cuts with a diagonal cutter will help this.
The pins should protrude slightly above the print before sliding the flash head on.
I rounded the pin ends before the final install. Mount the build, insert the pins and then the flash.
Check to see if every thing is pushed all the way in. May require some movement to seat the pins.
I believe it can be purchased on line as a C-S1 Hot Shoe Converter Adapter
for Canon/Nikon Camera to a Sony/Minolta Flash.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
