Thingiverse
Hotend - Nova V1.2
von bouffffi7
4
Downloads
2
Likes
0
Makes
Adding a Hotend support for the Nova V1.2 from 3D Passion.
This is compatible with Hypercube Ngen V2 X Carriage and the hotswap system
It features 2x 5010 fan blower for a maximum cooling capacity at highspeed.
The fixation of the hotend is done by the 2x M2 screw on top of the heatsink. a PTFE connector PC4-M6 is completing the assembly for a bowden system.
Careful on the DB15 pins : Depending on the manufacturer, it seems to take 3-5amps per pin. I am using a 24V 70W cartridge so around 3amps and no issue.
Tested and working, but might need some improvement
This is compatible with Hypercube Ngen V2 X Carriage and the hotswap system
It features 2x 5010 fan blower for a maximum cooling capacity at highspeed.
The fixation of the hotend is done by the 2x M2 screw on top of the heatsink. a PTFE connector PC4-M6 is completing the assembly for a bowden system.
Careful on the DB15 pins : Depending on the manufacturer, it seems to take 3-5amps per pin. I am using a 24V 70W cartridge so around 3amps and no issue.
Tested and working, but might need some improvement
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!