Thingiverse
HotShot Stabilizer Mounts
by Qbee
3
Downloads
2
Likes
0
Makes
A set of plates and arches for the HotShot stabilizer arm mounts.
Be aware that although the width of the plates is designed at 16mm, it can be much wider on an FDM printer. Mine came out at around 16.3 to 16.4mm. So I did need to clean them up with a file. If you do not do this, the effect is that your gear box will not properly close anymore. So be sure to measure after printing. The holes in the plates are designed at 1.8mm to get a good fit with the screw. The holes in the arch are at 2.2 to get an easy install.
Be aware that although the width of the plates is designed at 16mm, it can be much wider on an FDM printer. Mine came out at around 16.3 to 16.4mm. So I did need to clean them up with a file. If you do not do this, the effect is that your gear box will not properly close anymore. So be sure to measure after printing. The holes in the plates are designed at 1.8mm to get a good fit with the screw. The holes in the arch are at 2.2 to get an easy install.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!