Thingiverse
HotSwap BL Touch mount E3D V6
von maddash1337
23
Downloads
17
Likes
0
Makes
Because I wan't quickly switch my toolheads on my printer (V6 and Laser) I created this "hotswap" BL Touch E3D V6 mount for MGN12.
So the idea is - you will setup your BL Touch once and you can swap your tools without any / very litte changes in vor Z calibration.
DON NOT forget to change your probe offset values in the firmware.
(Values attached as image)
I printed it - but at least on my setup it's not working 100%.
I will create a better version of it
So the idea is - you will setup your BL Touch once and you can swap your tools without any / very litte changes in vor Z calibration.
DON NOT forget to change your probe offset values in the firmware.
(Values attached as image)
I printed it - but at least on my setup it's not working 100%.
I will create a better version of it
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
