Thingiverse
Hotwire Cutter Body
7
Downloads
4
Likes
0
Makes
This is a basic hot-wire cutter body I came up with for a foam cutting project.
I printed the model with standard print settings as it does not not need to look very pretty. If the rods are a tight fit into the hole use a bit of sandpaper to open the holes up. You do want to make the fit snug so the rods do not move.
Other items required:
3/16" brass rods for holding the wire
cutting wire http://a.co/2X1GD37 (what I used)
12V high amp power source (using an old computer power supply)
heatshrink tubing to hold the wire to the rod
I printed the model with standard print settings as it does not not need to look very pretty. If the rods are a tight fit into the hole use a bit of sandpaper to open the holes up. You do want to make the fit snug so the rods do not move.
Other items required:
3/16" brass rods for holding the wire
cutting wire http://a.co/2X1GD37 (what I used)
12V high amp power source (using an old computer power supply)
heatshrink tubing to hold the wire to the rod
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
