Housing for the camera sensor

This is a remix of the camera sensor from tomil1.

https://www.thingiverse.com/thing:1408927

The case itself supports 38x38mm sensor board fairly common for most CCTV cameras, I enlarged the whole for the wire to allow a PoE cable to fit through it (1.25mm). Though I wanted to modify it more I left it fairly stock I did use a small drill bit to enlarge the support holes and placed M2x5mm Cylindrical/Pillar standards off so I can mount the camera without affecting the IR cut filter module. (4xM2 5mm screw, 4x1mm M2 spacer, 4xM2x5mm Cylindrical/Pillar standards off )

The remaining parts work as is from his post. I'll be testing a few other boards and may make additional modifications.