Thingiverse
Housing for the Raspberry Pi Camera
von allan3D
16
Downloads
7
Likes
0
Makes
The two parts are prepared for assembly around the camera board with two 6mm ø2 screws as shown. The rings on the back are for connection with LEGO parts - see the photo of a tilt model, which uses the black tight fit plugs. Make your own Pan & Tilt mechanism with servo motors and Arduino!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
