Hoverboard hub motor mount

Hoverboard hub motor mount
====================


This mount is for when you are recycling Hoverboard motors and using them by screwing them to something flat, perhaps a piece of wood.

There are four optional countersunk screws around the edge to hold the mount in place.

The main four holes are for you to re-use the original securing plate from the Hoverboard. You'll need to drill through whatever you've mounted this to and get some suitable length bolts, the original hex head fasteners won't be long enough.

I have also included a 3D printable clamp but would not recommend this for anything but the lightest of loads, the metal plates are far far better as they keep the mount under strong compression.

The fifth large hole is if you want to pass the motor cable up through the thing you've secured the mounting plate to. You'll need to drill a similar sized hole with a flat wood bit or small holesaw.