Thingiverse
Hoverboard Quadcopter
door Crimson_Ghost
3
Downloads
3
Likes
0
Makes
I took inspiration from Jara fpv and designed my own frame.
This has universal motor mounts for 9x9 or 12x12 motors, whoop aio and 20x20 stack mounts, intigrated battery strap slots and can use the larger Twig mutant canopy.
It can also run 3" or 4" props.
My build is a transtech f7hd 35a 20x20 stack, caddx vista, crossfire nano, 1404/3750kv motors and 4024 bi-blade props.
Print with 100% infill and petg, i dont think pla will hold up at all.
Once printed you may have to clean out the bolt holes throughout the frame, The bolt holes are tight and meant for the bolts to bite into the frame to help with rigidness.
I'm running a 4s 650mah lipo and getting close to 4 min of freestyle flying.
When mounting the motors, 1 and 4 are on top and 2 and 3 are on bottom. Also make sure it is set for props out configuration.
This has universal motor mounts for 9x9 or 12x12 motors, whoop aio and 20x20 stack mounts, intigrated battery strap slots and can use the larger Twig mutant canopy.
It can also run 3" or 4" props.
My build is a transtech f7hd 35a 20x20 stack, caddx vista, crossfire nano, 1404/3750kv motors and 4024 bi-blade props.
Print with 100% infill and petg, i dont think pla will hold up at all.
Once printed you may have to clean out the bolt holes throughout the frame, The bolt holes are tight and meant for the bolts to bite into the frame to help with rigidness.
I'm running a 4s 650mah lipo and getting close to 4 min of freestyle flying.
When mounting the motors, 1 and 4 are on top and 2 and 3 are on bottom. Also make sure it is set for props out configuration.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!