Thingiverse
Howme the robot
door manchi
72
Downloads
83
Likes
0
Makes
This is a work in progress. All files will be uploaded later. The robot is a design of my own any ideas on how to make it look better are welcome :)
The parts are designed and exported to stl using SolidWorks.
The robot has its own website http://howme.net , but it is still under major changes.
These are the printable parts (at their current state) of my robot. This is its third version. All parts are designed to fit with a cheap MG995 servos. They are standard servo sizes so most servo machines may match (if the design works as I expect I am planing to supply it with better servos). The whole robot is powered by 15 servo machines.
The head is equipped with a wireless pinhole camera, laser, Sharp infrared sensor, two microphones in its ears (there is a room for pre-amp), a place for a RGB diode as a nose, at the top there is a place for a motion sensor.
(*The Bill of materials with links will be updated later.)
I was running all servos using Arduino Mega, but I am swi
The parts are designed and exported to stl using SolidWorks.
The robot has its own website http://howme.net , but it is still under major changes.
These are the printable parts (at their current state) of my robot. This is its third version. All parts are designed to fit with a cheap MG995 servos. They are standard servo sizes so most servo machines may match (if the design works as I expect I am planing to supply it with better servos). The whole robot is powered by 15 servo machines.
The head is equipped with a wireless pinhole camera, laser, Sharp infrared sensor, two microphones in its ears (there is a room for pre-amp), a place for a RGB diode as a nose, at the top there is a place for a motion sensor.
(*The Bill of materials with links will be updated later.)
I was running all servos using Arduino Mega, but I am swi
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!