Thingiverse
Hp Probook 6570B Latch Slide Button
von Havoc481
5
Downloads
4
Likes
0
Makes
Made a replacement Part for an Hp Probook 6570b.
It is the latch button you slide to open the lid of the laptop with.
i did not put the hooks on the bottom as it would not slide into the two points it connects into. i plan on using a heat source to slightly melt the plastic in place so it does not pop out. if anyone can model it up to where it can be don with out doing so i would greatly appreciate it.
If you guys need to mod it feel free to do so.
it was printed on a XYZ pro 3-in-1.
at 90% infill
.1mm height.
minor cleaning needed.
It is the latch button you slide to open the lid of the laptop with.
i did not put the hooks on the bottom as it would not slide into the two points it connects into. i plan on using a heat source to slightly melt the plastic in place so it does not pop out. if anyone can model it up to where it can be don with out doing so i would greatly appreciate it.
If you guys need to mod it feel free to do so.
it was printed on a XYZ pro 3-in-1.
at 90% infill
.1mm height.
minor cleaning needed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
