HP USB-C Essential Docking Station box

Box for HP Low docking stations like pn: 72C71AA#ABB or 784Q9AA#ABB etc.

It is possible print grommet for USB-C cable and then drill 13mm hole. I printed grommet in one piece from TPU 98, then cut it open on one side with a sharp paring knife. This "setup" is best becaouse grommet in table look like one piece. Second possibility is print it from PET-g etc. in two pieces, it is still look good, but TPU version is better.

Or use side "clip" on the table edge with some better double-sided tape or screws.