HPA buttstock
von Wald0
191
Downloads
160
Likes
1
Makes
HPA 13c Buttstock
Currently, on version 4 as I did change inner diameter to 50.50mm as I found out that while to Tippmann 13Ci is 50.48, FS 13Ci is 50.12 and it was impossible to tighten to the bottle when inside was 51mm
Currently printing 1.11
V4 (50.5mm) fits perfectly over FS 13Ci but not to Tippmann
V5 inner part is 51mm and should fit Tippmann bottles too, V4 inner part is 50.5 but because shrinkage it will be close to 50.1 on my ABS.
UPDATE: With ABS V5 will fit FS and Tippman bottles.
Currently, on version 4 as I did change inner diameter to 50.50mm as I found out that while to Tippmann 13Ci is 50.48, FS 13Ci is 50.12 and it was impossible to tighten to the bottle when inside was 51mm
Currently printing 1.11
V4 (50.5mm) fits perfectly over FS 13Ci but not to Tippmann
V5 inner part is 51mm and should fit Tippmann bottles too, V4 inner part is 50.5 but because shrinkage it will be close to 50.1 on my ABS.
UPDATE: With ABS V5 will fit FS and Tippman bottles.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
