Thingiverse
HubCap Displayer/Holder
von 3JulianD
0
Downloads
0
Likes
0
Makes
I Made this simple HubCap/Emblem holder for my BMW X1. It fits 4 caps, the holes got a diameter of 67mm. It stands at an angle of 70 degrees.
I will make one with a different diameter size in the near future.
Leave a tip if you like it.
Stay hot (just like your extruder)
I will make one with a different diameter size in the near future.
Leave a tip if you like it.
Stay hot (just like your extruder)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
