Hue Berker Dimmer switch mount

This is a remix from https://www.thingiverse.com/thing:398515


When I looked into printing some holders for my hue dimmers that would work with my installed light switch hardware I found this thing.

unfortunately there were some issues in the model. And I needed a 1 to 3 holder aswell.

So I redesigned the part with some improvements, like the chamfer on the outer edge for better surface finish and interfaces between hardware of the print and berker.

They both fit well within on a bed width of 225mm. any smaller and it might be problematic.
On my Ender 3 pro I had no issues with 235mm width