Thingiverse
Hue Play Lightbar Mount
por dctsystems
5
Descargas
3
Likes
0
Makes
Yet another Hue Playbar mount. This one goes over a bold, so I could mount it on the arm that holds my monitors.
The hole for the bolt is about 10mm - you can either mod the model or just file it out if you need it a bit bigger. Printed at 40% infil for strength, it seems fine.
In the preview above there's weird line where one of the boolean ops hasn't resolved properly. It should be solid when it prints but check in your slicer.
The hole for the bolt is about 10mm - you can either mod the model or just file it out if you need it a bit bigger. Printed at 40% infil for strength, it seems fine.
In the preview above there's weird line where one of the boolean ops hasn't resolved properly. It should be solid when it prints but check in your slicer.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!