MakerWorld
Hueforge & Lithophane
Zum Modell
HUEFORGE FERRARI
29
Downloads
24
Likes
18
Makes
HUEFORGE FERRARI Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mm Filaments Used: PETG JAYO Black Transmission Distance: 0.3 PLA BambuLab Basic Jade White Transmission Distance: 4 PLA BambuLab Basic Red Transmission Distance: 5 !!!! It appears you have mixed filament types. Be certain this is what you want. !!!!! Swap Instructions: Start with Black At layer #3 (0.36mm) swap to Jade White At layer #11 (1mm) swap to Red for the rest. ADVISE: If you want to change the color of the car, instead of red, use the one you like best.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
