Hueforge - Naruto - Best Scene

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmFilaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Red Transmission Distance: 4 PLA BambuLab Basic Orange Transmission Distance: 5 PLA BambuLab Basic Yellow Transmission Distance: 6 PLA BambuLab Basic Jade White Transmission Distance: 3Swap Instructions: Start with Black At layer #18 (1.52mm) swap to Red At layer #23 (1.92mm) swap to Orange At layer #24 (2mm) swap to Yellow At layer #28 (2.32mm) swap to Jade White for the rest. **IMPORTANT INFORMATION**You cannot adjust the z scaling on any hueforge. This will mess with the coloring done and your hueforge will not come out as intended. You can however change the x and y to scale the picture. I recommend only changing by the same percentage. To get an accurate print as shown in the photos you MUST use the same filaments listed below. You can change brands (as long as they are similar) but keep the filament colors the same. I