Hueforge Naruto

Hueforge NarutoBoost Meboost me please :p:d Project: naruto.hfpPrint at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 200x200mm in sizeYou may print at higher layer heights below the Min Depth of 0.48mmThe Max Depth is 2.2mm and the Actual Depth is 2mm Filaments Used: PLA PolyLite Black Transmission Distance: 0.3 PLA Sunlu Dark Grey Transmission Distance: 0.2 PLA Sunlu Silver Transmission Distance: 2.1 PLA PolyLite White Transmission Distance: 5This print uses 4 unique filaments Swap Instructions: Start with Black At layer #8 (0.72mm) swap to Dark Grey At layer #11 (0.96mm) swap to SilverThis slider is set higher than the mesh depth. It is not affecting your final mesh. Consider removing it. At layer #24 (2mm) swap to White for the rest. Please leave a comment and like if you like my Hueforge. Thank you very much.Non-commercial !!!