MakerWorld
Hueforge & Lithophane
Vai al Modello
Hueforge Pokemon
37
Download
47
Likes
11
Makes
DescriptionPrint at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 200x245mm in sizeYou may print at higher layer heights below the Min Depth of 0.48mmThe Max Depth is 2.2mm and the Actual Depth is 2.3mm Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.3 PLA BambuLab Basic Blue Transmission Distance: 4 PLA BambuLab Basic Red Transmission Distance: 4 PLA BambuLab Basic BambuLab Green Transmission Distance: 2 PLA BambuLab Basic Yellow Transmission Distance: 6This print uses 5 unique filaments Swap Instructions: Start with Black At layer #8 (0.72mm) swap to Blue At layer #10 (0.88mm) swap to Red At layer #18 (1.52mm) swap to BambuLab Green Border Only Colors from here until the end. At layer #19 (1.6mm) swap to Yellow for the rest. if you like feel free to give me a boost THANKSBoost Me
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
