humangear capCAP+ TPU-strap

This design is the TPU version of this: https://www.thingiverse.com/thing:4575223

For best results and a durable strap make sure the part is oriented at a 45 degree angle on the printbed. The layer orientation of the strap should NEVER be perpendicular to this alignment. The first and last layer of the flat part of the strap should align in the diagonal direction, as shown in the images. The orientation of the layers between them sould be at a 45 degree angle to the diagonal axis. One image shows the correct settings (unfortunately the first two digits are cut off in the image. It is [45, 90, 180,45, 90,180,45]) of the orientation for a layer height of 0.2 mm.