Hummingbird Feeder

Plastic Bottle Base:
I would look in the kitchen or grocery store for a round plastic container where the cap fits the plastic bottle base.

Plastic Bottle:
I used a 1 quart plastic vinegar bottle for one and a plastic beverage bottle for the second. Remove plastic safety ring. Drill 2-1/4" holes through bottle side (and cap if necessary) about 5/8" from the end of the cap. Location of holes will will determining liquid height. Liquid closer to the bottom of the flower is best.

Wine Bottle Base:
Used a cork type wine bottle. Just push the open end into the base. The base will provide about 7/8" of liquid in the bottom container.

Flower:
I printed a flower @ 60% speed for about 12 minuets and then reduced to 40% speed for the stem. Slow speeds will give better results. A timer will help. Flower #1 has smaller petals and are for bottle clearance when necessary.

Tapered Mounting Rings:
They have a relief for getting closer to the lid edge. 2 per flower.

Pl