Hummingbird & Fuchsia clock

You can use the components from here: https://us.store.bambulab.com/products/clock-components-kit-011 The back mounts with M2.5 x 6mm long screws (same as my pen models) https://www.mcmaster.com/92010A016/ This is made with layers so it can be printed with a single-color printer. Use 0.8mm layer heights once you've printed the clock face. 8 colors in total in 9 sections. White, yellow, gray, white, red, green, pink, purple, black. To print with a single color printer, insert pauses at each color change layer (Cura > Post Processing >Modify G-code > Pause at layer)To print with a Bambu and a 4 color AMS, Load up White, Yellow, Gray, Red into slots 1-4. Tell it to print Green, pink, purple, & black with slots 1-4 as well. Start the print, then immediately remove the red material. This will cause the printer to stop when it reaches that color and wait for you to load material. When you load Red, pull out white, yellow, and gray. Place the Green and Pink into slots 1 & 2 (slot 3 will b