Husky Handle Holder

[Holder in action.](https://youtu.be/SCFiSheFAMs)

A holder I designed for the famous [Husky standing desk](https://www.homedepot.com/p/Husky-72-in-Adjustable-Height-Work-Table-HOLT72XDB11/307654222). The magnet used is from [McMaster - Carr](https://www.mcmaster.com/5862K103/) attached with Loctite super glue. Then I just super glued the part to the bottom of my desk.

I went with Siraya Tech's Mecha White resin because its much more resistant to sliding friction than other resins I have tested and this part wont be seeing any other forces. Print time took about 6.5 hours. A large part of this is the long resting time after retraction. You can shorten this to zero but the surface finish will be awful.