Thingiverse
Husky Table Hand Crank
por Jglenn87
3
Descargas
1
Likes
0
Makes
I lost the hand crank for my rolling Husky Table that cranks the tabletop up or down. It's a 10MM Hex Bit molded into a hand crank that I found on thingiverse.
Version 1.
The torque for my table is not a ton - So a 50% infill should be sufficient.
1 Inch #10 Screw to connect the hande and knob.
Version 1.
The torque for my table is not a ton - So a 50% infill should be sufficient.
1 Inch #10 Screw to connect the hande and knob.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
