Husky Toolbox Drawer Labels

Props to kvn5x4 for the original model. That one was flat and square and I wanted something with a 15 degree upward angle and chamfered corners. This will clip on if you start with the bottom “hook” first, engage that then push the top in place and it will snap on very tightly. I recommend removing the end caps and sliding it off if you need to remove it- I don't know how many on/off cycles it will last. Definitely print it on end for ideal layer line strength. I'm using an IR laser to label but you can use any label you have access to, even printed labels. The working area is 76mm x 25.8mm for reference. If you'd like to leave a tip/buy me a coffee I'd appreciate it!Boost MeBoosts are always appreciated!