HW40/P17 Suppressor Adapter

Silencer adaptor for use with Weihrauch HW40/Beeman P17.

Fits 1/2-20 UNF threaded moderators.

Held in by friction.

The options to use a suppressor with the HW40 were limited. This works pretty well. Only issue is that when attached, a silencer is too wide to allow the pistol to open fully, meaning it must be removed and reattached to load the airgun. As it's only held in with friction, it can be pulled out, loaded, and put back in.

When printing, print it on it's side - rotate the mesh 90 degrees in Cura. It snaps in half really easily if you print it pointing up.

The part that inserts into the muzzle break is 18mm long with 10mm diameter, which may mean it can be used in other airguns. I suspect it works with other knockoffs too, such as the Xisico XSP120D or the AirForceOne NTK BUSTER.

If the thread is too tight, print it thinner - 99.5% scale on the relevant axes. Keep it the same length - that axis should be 100%.

This has nearly 500 downloads, and no one has p