Hydra - Test Pieces

Support All my designs and mods are free to use and remix. They have a non-commercial license. If you enjoy this or any of my other designs you can send me a small donation using the link below. Thanks :) https://www.paypal.me/humebeamengineering About This is a set of two different test pieces to print before printing the big Hydra parts. You need some calipers to measure the printed parts. The first test is to print the roller slots and the second is the dovetail joints. Make sure you dial in flow correctly before you start, we've seen a few Hydra prints that were overextruded so avoid that. The problem then is you can't join the dovetail joints and therefore assemble properly without sanding them down a little, you can also get problems with the rollers binding. The Bambu Lab printers usually do a pretty good with automatic flow calibration but it's best to confirm flow anyway, sometimes it is inaccurate. First, print the roller test piece, print it in the direction I have set it. M