Thingiverse
Hydraulic Press Lighting System
door Charlez951
0
Downloads
0
Likes
0
Makes
This is a powerfull lighting system I made for my 12T hydraulic press but it fits onto any press made from steel C-channel measuring 1.5 x 3.0 inches. (see https://www.thingiverse.com/thing:7249289 for other improvements of hydraulic press) .
This lighting system is made out of a 80mm car/motorcycle auxiliary white LED headlight ring from AliExpress (search for "Halo Rings", typically around than 5$). These are super bright and provide uniform lighting.
It's the same LED ring I used in these projects:
https://www.thingiverse.com/thing:6833269
https://www.thingiverse.com/thing:6822878
The main difference in this version is that I didn’t use the clear lens that normally goes over the LED ring. Instead, I glued the LED ring directly to the 3D-printed holder without lens. Use cyanocrylate gel or use with epoxy for more durability.
I decided not to include a dedicated power supply, since the one on the Dremel workstation isn’t used often. Instead, both projects share the same power so
This lighting system is made out of a 80mm car/motorcycle auxiliary white LED headlight ring from AliExpress (search for "Halo Rings", typically around than 5$). These are super bright and provide uniform lighting.
It's the same LED ring I used in these projects:
https://www.thingiverse.com/thing:6833269
https://www.thingiverse.com/thing:6822878
The main difference in this version is that I didn’t use the clear lens that normally goes over the LED ring. Instead, I glued the LED ring directly to the 3D-printed holder without lens. Use cyanocrylate gel or use with epoxy for more durability.
I decided not to include a dedicated power supply, since the one on the Dremel workstation isn’t used often. Instead, both projects share the same power so
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!