Hygrometer Holder for Multiboard

Design ConceptThe Hygrometer Holder is created to securely attach a standard hygrometer to a Multiboard system, allowing for optimal monitoring of environmental conditions.This is a remix. The original was made by MG Prints over at Makerworld. (Link at the bottom of this page).I printed the original, but it was too tight. My hygrometer came apart when I tried to remove it from the holder, so I made some changes...ChangesChanged the overall shape to give it slightly more round look,Increased the diameter,Cut 5mm from the total depth.Printing AdvicePrint with PLA0.20mm Layer Height10% Rectilinear InfillTree support neededAssembly InstructionsThe holder can be used with or without the Multiboard Snap depending on your setup. I included a single Multiboard Snap as an STL.If you find this remix useful in any way, please leave me a LIKE. Happy Printing!