Thingiverse
Hyken Headrest riser + stubby
von Shveety
2
Downloads
3
Likes
0
Makes
TLDR: Flattened off the sides to be able to print sideways for strength, the same way that Singularities did (over on Printables.com)
but also shortened up the headset.
Stubby version can use support but it doesn't appear to be needed overall. but can use supports at 70degees
stubby is approximately 250mm shorter than the original.
overall, 50% infill isn't needed but was used from a bit more strength (broke one mount already that was printed in a different direction)
1/4-20 bolts seem to thread into it just fine
but also shortened up the headset.
Stubby version can use support but it doesn't appear to be needed overall. but can use supports at 70degees
stubby is approximately 250mm shorter than the original.
overall, 50% infill isn't needed but was used from a bit more strength (broke one mount already that was printed in a different direction)
1/4-20 bolts seem to thread into it just fine
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
