Thingiverse
Hylian Shield Alignment Pin
door Galaxy_3D_Works
4
Downloads
5
Likes
0
Makes
I made my own alignment pins for this shield.
You will need 10 of these. Print at 100% infill and brims on so they stay in place. Lay flat on the long side.
All 10 took less than 10 minutes to print on my X1Carbon at standard speed. Nice snug fit.
You will need 10 of these. Print at 100% infill and brims on so they stay in place. Lay flat on the long side.
All 10 took less than 10 minutes to print on my X1Carbon at standard speed. Nice snug fit.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
