Thingiverse
Hyper X Carriage
di DeeChen
8
Download
3
Likes
1
Makes
Keeping true to Tech2C's ideal of keeping the X axis set up as light as possible, I experimented with using balsa wood and also integrating different elements that went into the whole X carriage set up to minimise parts and screw counts. In the 2nd iteration, i did away with the brass bushing and also raised the Z clearance.
https://www.facebook.com/groups/1871049783171141/permalink/1962681270674658/?comment_id=1963679073908211&comment_tracking=%7B%22tn%22%3A%22R0%22%7D
Notes
--------
-The 5015 fan is an integrated part of the whole structure thus have it tighten down properly.
-The Con of this design is that it becomes harder to swap out the hot ends if need be.
-Silicon sock for the hot end is also a must, as the placement of the BL touch is very close. I highly recommend protecting your BL touch with some Kapton tape and cork sheet.
Fans
----------------------
5015 blower fan x 1
40mm radial fan x 1 (The fan issued together with the hot end/heat sink)
Screws
https://www.facebook.com/groups/1871049783171141/permalink/1962681270674658/?comment_id=1963679073908211&comment_tracking=%7B%22tn%22%3A%22R0%22%7D
Notes
--------
-The 5015 fan is an integrated part of the whole structure thus have it tighten down properly.
-The Con of this design is that it becomes harder to swap out the hot ends if need be.
-Silicon sock for the hot end is also a must, as the placement of the BL touch is very close. I highly recommend protecting your BL touch with some Kapton tape and cork sheet.
Fans
----------------------
5015 blower fan x 1
40mm radial fan x 1 (The fan issued together with the hot end/heat sink)
Screws
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
