Thingiverse
Hyperbolic paraboloid
von sanblangar
6
Downloads
7
Likes
1
Makes
This is a hyperbolic paraboloid with incorporated supports.
Adjust resolution as shown in the pictures: from 0.05mm to 1mm or whatever works for you.
Turn thin walls off and select a middle slicing tolerance.
Use a raft with 0mm air gap.
Additional supports for the middle may be needed if you want a really smooth bottom side, but it prints just fine without them.
Adjust resolution as shown in the pictures: from 0.05mm to 1mm or whatever works for you.
Turn thin walls off and select a middle slicing tolerance.
Use a raft with 0mm air gap.
Additional supports for the middle may be needed if you want a really smooth bottom side, but it prints just fine without them.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!