Thingiverse
Hypercube 3D Printer - Adjustable/Extended Fan Duct (For clone/different hotends)
by Sterminare
34
Downloads
23
Likes
0
Makes
I built Tech2C's Hypercube, but the fan duct is too short for my e3D v6 Clone. Its blowing directly onto the heater block. If you decide to make one, please upload a make. I would love to see how yours turn out
With this, the fan duct can be adjusted 2mm up or down by sliding the screw in the slot.
At it's highest, it's the same as the default duct. At it's lowest, it's approximately 2mm below the default. I have mine adjusted to ~1.5mm below default.
I also removed 2mm from the top of the duct, so it doesnt bottom out on the fan itslef, preventing movement.
Note it may require a little filing. You do not want the screw's threads to engage in the slot. I personally have mine somewhere in the middle of the range.
With this, the fan duct can be adjusted 2mm up or down by sliding the screw in the slot.
At it's highest, it's the same as the default duct. At it's lowest, it's approximately 2mm below the default. I have mine adjusted to ~1.5mm below default.
I also removed 2mm from the top of the duct, so it doesnt bottom out on the fan itslef, preventing movement.
Note it may require a little filing. You do not want the screw's threads to engage in the slot. I personally have mine somewhere in the middle of the range.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
