Thingiverse
Hypercube 50mm Adjustable Leg
door armakaryk
71
Downloads
64
Likes
0
Makes
These legs for the 2020 bottom corners on the Hypercube (or any 2020 cube frame) allow you to raise the bottom extrusions off your workbench anywhere between 50-80mm. Each foot is easily adjustable to allow for compensation of uneven worksurfaces. These also allow you to remove the inner 20mm brackets.
Print Recommendations:
I printed these in PETG with 3 perimeters, 6 top/bottom layers, and 20% gyroid infill. I also printed relatively hot so I could get better layer adhesion, so I had to use supports for the nut and screw head slots. All of this was likely overkill on my part, but I do intend for this to be a pretty mobile printer so I wanted something that I knew wasn't gonna give out on me any time soon.
Required Hardware:
8x 10mm M5 bolts and M5 T-Nuts (you should have these lying around from constructing your Hypercube)
4x 30-40mm M8 Hex Bolts with Nuts (or 1-1/2" - 2" 5/16 SAE Hex Bolts, SAE nuts are thicker than M8 nuts so they will be a bit proud, this doesn'
Print Recommendations:
I printed these in PETG with 3 perimeters, 6 top/bottom layers, and 20% gyroid infill. I also printed relatively hot so I could get better layer adhesion, so I had to use supports for the nut and screw head slots. All of this was likely overkill on my part, but I do intend for this to be a pretty mobile printer so I wanted something that I knew wasn't gonna give out on me any time soon.
Required Hardware:
8x 10mm M5 bolts and M5 T-Nuts (you should have these lying around from constructing your Hypercube)
4x 30-40mm M8 Hex Bolts with Nuts (or 1-1/2" - 2" 5/16 SAE Hex Bolts, SAE nuts are thicker than M8 nuts so they will be a bit proud, this doesn'
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
