Thingiverse
Hypercube Evolution Trim Panel Enclosure
von diablex
9
Downloads
1
Likes
0
Makes
Trim panel with counter sunk holes to mount on to 3030 extrusion for 100mm lower bar spacing on the Hypercube Evolution.
This is for 300x300x300 chassis.
The mounting holes will be eliptical. You need to make them round with a hex screw driver.
This is for 300x300x300 chassis.
The mounting holes will be eliptical. You need to make them round with a hex screw driver.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!