Thingiverse
HyperCube Evolution Ultimate Direct Drive Upgrade (BLTouch + BMG extruder)
von benvrakas
21
Downloads
12
Likes
0
Makes
This printhead balances the mass of the stepper motor against the other components to reduce the twist on Y gantry. It is compact and rigid.
It uses a V6 Hotend, BMG extruder, 5015 blower fan and BlTouch. The Y carriage uses 20mm wide microswitches with 9.5mm hole placement for X and Y endstops.
M3 Hardware all around.
Optional 40mm fan duct for heatsink
It uses a V6 Hotend, BMG extruder, 5015 blower fan and BlTouch. The Y carriage uses 20mm wide microswitches with 9.5mm hole placement for X and Y endstops.
M3 Hardware all around.
Optional 40mm fan duct for heatsink
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!