Thingiverse
HyperCube USB and Dimmer Bracket
door henryarnold
37
Downloads
32
Likes
1
Makes
This 3D Printer control panel combines a USB port and an LED Lighting Dimmer which can be mounted on any 2020 extrusion. I mounted mine on the front of my printer but it will work on the side or back as well. The USB port uses an extension cable that plugs into the controller. The other end screws to this panel. This panel makes it more convenient to connect your printer by placing the connector on the perimeter.
I used this USB extension cable which has a 90 degree bend on the male end and a panel mount connector on the female end:
https://www.amazon.com then search for "B01LRZ8GK2"
This is the LED Dimmer I used:
https://www.amazon.com then search for "B00HTZZF9A"
My LED Dimmer Thing:
http://www.thingiverse.com/thing:2009479
My HyperCube:
http://www.thingiverse.com/make:272257
I used this USB extension cable which has a 90 degree bend on the male end and a panel mount connector on the female end:
https://www.amazon.com then search for "B01LRZ8GK2"
This is the LED Dimmer I used:
https://www.amazon.com then search for "B00HTZZF9A"
My LED Dimmer Thing:
http://www.thingiverse.com/thing:2009479
My HyperCube:
http://www.thingiverse.com/make:272257
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!