Thingiverse
HyperCube Y Idler Improved and stronger
door n9jcv
112
Downloads
56
Likes
0
Makes
I am building a Hypercube. The existing Y idler looked to me to be a very weak part and the belt would put a lot of stress on it. I have redesigned it to make it stronger.
Designed to be bolted to the 2020 using 2 M5x10 screws. Use 2 washers for each bearing group, meaning on the inside and outside of each rectangular bearing holder. Total 4 washers. Use a single M3x40 to secure the bearings. Also I printed at 80% for strength
Source Sketchup 2017 file also included.
Designed to be bolted to the 2020 using 2 M5x10 screws. Use 2 washers for each bearing group, meaning on the inside and outside of each rectangular bearing holder. Total 4 washers. Use a single M3x40 to secure the bearings. Also I printed at 80% for strength
Source Sketchup 2017 file also included.
n9jcv publiceert ook op
38 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!