Hyperfire OLED mount rear rail

This is a rear rail attachment for the Nerf Hyperfire with an OLED mount designed for those SPI/I2C 128x64 pixel displays.

It uses a combination of common nerf screws and #2 flat head screws for installation. I recommend filling in behind the mounting points inside of the blaster with some epoxy to make for a better point to screw it to the blaster. There are also 1/16" holes that can be used for alignment pins to make sure that it goes together nicely

You will need to use supports to get a good print. I layed it on the side face when printing and that worked well