Hyperlite Floss 2 Pod

This is a Pod for the Hyperlite floss 2 frame. If you want to use this thing, there are some parts you have to first think of:
-Your electronics stack can only be 26mm high
-you need to use a micro size camera
-it is recommended to use a linear antenna
-you need to be ok with removing the nuts under the standoffs in the back
-the cam angle only goes from 47 to 55, but you can melt or cut a bit of the plastic away to make room for another angle

To install this thing you need extra:
-2x m2x7mm screw
-2x m2 washer

Install:
First, put the cam in place. Then, use a washer and a m2x7mm screw to secure the camera on one side, then do the same thing on the other side. then tighten the screws to a point, where you still can move the cam up and down, but its sits tightly where it is.
Installing the pod in the front is simple: Just stick the pod on the 16mm screws and put a self tightening lock nut on it. in the back, just screw it on the standoffs. Finally, put your antenna throug