Hyperlite Floss 3.0 widget

so I made this thing. It goes on the back of the aluminum plate on the FLOSS 3.0. What it does is provide strain relief to THE strain relief. The way the aluminum plate is cut with slots , if one has the power leads coming out the back and decides to zip tie them to the aluminum plate, it will pull down on the leads and consequently the esc/fc stack. This widget sits in the gap in between and takes up the space. This way when you cinch up the zip tie the power leads does not get pulled down very far. My Hobby wing 4in1 45a esc cant sit flush on the aluminum plate. The two press nuts make contact with the esc. So I have them sitting on 2.5 mm risers I printed so this raises the stack a little and so the need for this widget..

This thing sits 4 mm above the ridges on the aluminum plate. IF you stack is lower or higher it will need to be printed/scaled smaller