Hyperlite Floss 7" DJI command center

This is my take on Kevpv floss command center. it is not technically a remix of his, but very very influenced by his.

this is made to take a full sized DJI air unit and use the stock antennas. the AU slips into the mount there is a hole for a zip tie to hold the AU in. the FPV camera mounts to the HD camera so they will always be in the same plane. the cameras are adjustable from 10-40*

there is a spot behind the AU mount to mount your RX

I also put the GPS mount flat so if you would like to use INAV you do not have to do custom magnetometer angle settings. there is a hole just under the GPS for a zip tie to secure the GPS.

you will need 2 3x10mm standoffs for the camera mount. plus 4 3x10mm screws. I suggest using a good washer on the upper camera mount screws to help spread the load. there are two holes in the base of the tower for zip ties to help stabilize the tower to the top plate.

the v5 tower is made to use a standard immortal T antenna

the v4 tower has a S