I Am Groot HueForge

Artwork from Pinterest, author not found.Then used HueForge v0.9.1 to create the model. Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm.Size is 150x200mm. You can only modify the X and Y dimensions. Do not adjust the height (Z) in your slicer! The layers would not be correct. You may print at higher layer heights below the Min Depth of 0.56mm. The Max Depth is 2.32mm and the Actual Depth is 2.32mm It is possible to print without AMS by manually changing the filament (setting filament change or pause) in the slicer, depending on your printer and sw support. Filaments Used: PLA Elegoo + Black Transmission Distance: 0.3 PLA Sunlu META Grey Transmission Distance: 3.6 PLA Elegoo + Gray Transmission Distance: 3 PLA Elegoo Basic White Transmission Distance: 7This print uses 4 unique filaments Swap Instructions: Start with Black At layer #10 (0.88mm) swap to Grey At layer #15 (1.28mm) swap to Gray At layer #20 (1.68mm) swap to White for the rest. Share your print